Take your existing system to the next level. PyroNext turns a single controller cue into a fully routed, multi-position show — sequenced deep at one rack, or fired together across many. Your existing controller stays in charge.
In plain English: PyroNext lets you keep your existing firing controller while adding smarter routing, better continuity visibility, and safer field setup — between your controller and your igniters.
Keep your controller
Works downstream of a wide range of existing firing systems crews already own. No replacement required.
See problems before arming
Per-igniter continuity visibility and real-time field status — before showtime, not during.
Reduce field chaos
Cleaner wiring, smarter routing, and better rack-level information on every job.
The routing story
A single cue from your existing controller can drive one igniter — or it can drive dozens, sequenced or synchronized, depending on the IQ Slat variant you choose at each position.
Deep sequencing at one position
Use IQ Slat 9 for fewer, larger banks — ideal when one cue should fire a long sequence of igniters at a single rack.
Synchronized across many positions
Use IQ Slat 36 for many small banks — ideal when one cue should fire simultaneously at several positions, like left-center-right.
The complete field layer
Concept render — Connect 12, EM2 Bridge, and IQ Slats working together on the firing line, the complete PyroNext field layer, illustrated.
Inside Connect 12
A single 7" display shows live output status for every port, adapting to whatever mix of IQ Slats you have connected. Before you arm, you know exactly where you stand.
EM2 Bridge — chainable legacy controller compatibility, field-deployed.
IQ Slat 9 — 108 outputs, E-Ink display, IP65.
Dig deeper into each component of the PyroNext system.
Plan in Studio. Fire through your existing controller. Bridge reads the signal. Route through Connect. Verify at the IQ Slats.
See exactly which connection needs attention before you arm — not just which cue has a problem.
If a firmware bug, a lost signal, or a power problem happens mid-show, PyroNext defaults to safe automatically. You don't have to trust the software to protect your crew — the hardware does it whether the software is behaving or not.
Works with a wide range of existing firing systems via field cable adapters. No new controller required.
Dust-tight and water jet protected. Built for the firing line, not the equipment room.
See exactly which connections are ready, which rack needs attention, and whether your power supply is healthy — all before you ever turn the key. No surprises once the show starts.
Every firing confirmation, every fault, every power reading — logged automatically. If an insurer or an AHJ ever asks what happened during a show, you have the answer in seconds, not guesswork.
How it works
Existing controller stays in charge. PyroNext makes everything downstream smarter.
Existing firing system
Works with your existing controller
EM2 Bridge
Reads trigger & continuity pulses
Connect 12
Routes · monitors · 24V firing
IQ Slats at the rack
Per-igniter continuity · shunt
Igniters
Up to 1,296 connections
Click any component to learn more
PyroNext adds an intelligent field layer between your existing firing controller and your igniters — smarter routing, better continuity visibility, and safer setup without replacing what you already own.